Panasonic KX-TG2258CS Operating Instructions Manual page 60

✿✤✦✪✣5Z✮_✩.❇m ✩✣
Troubleshooting
General
Problem
The unit does not work.
The unit does not announce
the displayed caller's name.
The unit does not announce
the displayed caller's name
properly.
Previously programmed
information is erased.
" Recharge battery " is
displayed, " " flashes or
the unit beeps intermittently.
You charged the battery fully,
but " Recharge battery " is
still displayed and/or "
continues to flash.
The IN USE/CHARGE
indicator light does not go out
after the battery has been
charged.
60
] ]
Cause & Remedy
• Check the settings (p. 8–10).
• Check whether the dialing mode setting is
correct (p. 14).
• Charge the battery fully (p. 9).
• Clean the charge contacts and charge again
(p. 10).
• Install the battery properly (p. 8).
• Place the handset on the base unit and
unplug the AC adaptor to reset it. Plug in, and
try again.
• Re-install the battery (p. 8) and charge it fully.
• The handset and base unit ringer volumes
are OFF (p. 18).
• The Talking Call Display feature is OFF
(p. 16).
• Name pronunciation may vary.
• The unit will announce each letter of
abbreviations, such as Co., Inc., etc.
• Call Display service supports names of up to
15 letters. If the caller's name has more than
15 letters, the name will not be announced
correctly.
• If a power failure occurs, programmed
information may be erased. Reprogram if
necessary.
• Charge the battery fully (p. 9).
• Clean the charge contacts and charge again
(p. 10).
" • Install a new battery (p. 8).
• This is normal.
_