Table of Contents
Advertisement
2. Restore - If you have a previously-saved profile, you can restore your previous configuration.
Click the Restore button.
A file location window will prompt. Locate the backup file, and click Open. The Restore
process will take several minutes to complete, and system operation will be interrupted during
the process.
3. Restore Default - There are two kinds of defaults for the NVR systems: System defaults and
factory defaults.
The system defaults can be restored using the reset button on the system panel (press for
5 seconds) . This applies when users forget about its IP address or login password, while
most other operation details will remain unchanged.
The factory defaults (operated on this window) restores to its primitive state before shipping,
and hence users' configurations (such as host name, IP address, and layout settings) will be
erased.
Click Restore to restore your system defaults. A warning message will appear. Click OK to
proceed. The Restore process will take several minutes to complete, and system operation
will be interrupted during the process.
A successful operation will produce the following message.
VIVOTEK - Built with Reliability
User's Manual - 133
Advertisement
Table of Contents
