NOTE:
If you press the Power button while the projector is running, the "Press
Power Button to Turn off Projector" message appears on the screen. To clear the
message, press the Menu button on the control panel or ignore the message; the
message disappears after 5 seconds.
Adjusting the Projected Image
Raising the Projector Height
Press the Elevator button.
1
Raise the projector to the desired display angle, and then release the button to
2
lock the elevator foot into position.
Use the tilt adjustment wheel to fine-tune the display angle.
3
Lowering the Projector Height
Press the Elevator button.
1
Lower the projector, and then release the button to lock the elevator foot into
2
position.
3
1
Elevator button
2
Elevator foot
3
Tilt adjustment wheel
18
Using Your Projector
1
3
http://www.pureglare.com.au
2