Amana P1212701R Service page 9

Installation Instructions
2. Measure, and lightly mark a line 8 11/16-inches from
window jamb.
NOTE: If any sash stop protrudes more than 1 inch from
side window jambs, 8 11/16-inch measurement
must be increased accordingly. Screen and
storm window frames may also require
adjustments to the measurement.
3. Center platform assembly on the line with inside
platform tab pressed against inside edge of window
track. Use holes provided in the platform as a guide,
mark and drill two 9/64-inch diameter holes. Drill
holes in either track or stool.
Alternate screw location
Window track
RS4110001 Rev. 0
11
8
16
Platform tab
Window seal
!
To avoid risk of property damage be sure the wood
stool or window track is securely attached to the
building construction. Use longer screws in the sub-
framing if necessary.
4. Remove protective backing from the track seal. Apply
seal to room side of the window track. Center of the
seal strip should coincide with the line marked in Step
3. Two screw holes drilled in Step 4 should be directly
above the seal strip in the inner track.
5. Securely attach siding-protection board to the side of
the house.
Inside
wall of
house
NOTE: Siding-protection board should be long enough
to reach 2 wall studs.
9
CAUTION
Apply track seal
to window side
of track.
Siding
protection
board