Amana P1212701R Service page 10

Installation Instructions
6. Place platform assembly, with platform tab against
inside of window track, and attach it to the window
jamb. Use appropriate length screws.
7. Adjust platform assembly so that the outside edge is
3/16-inch lower than the inside. This will ensure
proper water drainage from the air conditioner.
Platform tab
against inside
of track
8. Level platform assembly from side-to-side. Verify
window track is level. Use leveling shims as
necessary to ensure unit is level from side-to-side.
9. Measure distance from the top of platform assembly
to top of window opening. Subtract 20 1/2 to
20 5/8-inches. Mark this measurement on the plastic
window panel, along the longer side.
10. Clamp plastic window panel between a board and
work table, cut along the line with a fine tooth saw.
Remove any burrs with a file.
RS4110001 Rev. 0
Outside edge is
lower than inside
11. Fasten side channels to unit using 3 screws per
channel. Start with the first screw at the top of the
channel. Verify hook ends of the channels face
toward back of the unit.
12. Slide plastic window panel into panel frame, with
smooth side to the room. Slide panel frame assembly
into side channels of the air conditioner cabinet.
Verify plastic window panel is firmly enclosed on all
sides by retainer grooves.
Plastic
window
panel
13. Cut side channel seal into 2 equal lengths. Remove
protective backing and apply to rear side of cabinet
side channels, starting just below panel frame
assembly. Pinch off excess length so the seal is even
with the bottom of cabinet side channel.
Weather
seal
10
Panel
frame