Electrical Safety - Black & Decker BPGL2009 Manual

ENGLISH

Electrical safety

This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating plate.
• If the supply cord is damaged, it must be replaced by
the manufacturer or an authorised Black & Decker
Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Lock-off button
3. Side handle
5. Spindle lock
5. Guard
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting and removing the guard (fig. A)
The tool is supplied with a guard intended for grinding
purposes only. If the unit is intended to perform cutting off
operations, a guard specific for this operation must be fitted.
A suitable guard for cutting off operations part number
1004484- 03 is available and can be obtained from Black &
Decker service centres.
Fitting
• Place the tool on a table, with the spindle (6) facing up.
• Hold the guard (5) over the tool as shown.
• Align the holes in the adjusting plate (7) with the screw
holes (8).
8
• Press the guard down and insert the screws (9) into the
holes.
• Tighten the screws.
Removing
• Remove the screws (9).
• Remove the guard from the tool.
Warning! Never use the tool without the guard.
Adjusting the guard (fig. B)
The guard can be rotated 180°.
• Slacken the screws (9) and the nut (10).
• Rotate the guard as required.
• Re-tighten the screws and the nut.
Fitting the side handle
• Screw the side handle (3) into one of the mounting holes
in the tool.
Warning! Always use the side handle.
Fitting and removing grinding or cutting discs (fig. C - F)
Always use the correct type of disc for your application.
Always use discs with the correct diameter and bore size
(see technical data). The maximum thickness for grinding
discs is 6 mm, for cutting discs 3.5 mm.
Fitting
• Fit the guard as described above.
• Place the inner flange (11) onto the spindle (6) as shown
(fig. C). Make sure that the flange is correctly located on
the flat sides of the spindle.
• Place the disc (12) onto the spindle (6) as shown (fig. D).
If the disc has a raised centre (13), make sure that the
raised centre faces the inner flange.