Klutch MIG250S Owner's Manual page 9

ASSEMBLY
1. MIG TORCH ASSEMBLY
1.1 Locate the retaining bolt inside the front panel on the drive system. Loosen the retaining bolt.
1.2 Make note of the retaining groove on the back end of the MIG torch.
Retaining
Groove
Retaining
Bolt
1.3 Insert the back end of the MIG torch into the MIG socket on the front of your machine. Make
certain to completely slide the torch all the way in. Slightly twist to assist with pushing the torch to
the back of the receptacle. The retaining bolt can then be tightened, making certain the bolt sets
down into the retaining groove on the back of the MIG torch.
1.4 Connect the 5-Pin trigger connection on the MIG torch to the 5-Pin trigger receptacle on the
front panel.
1.5 Connect the ground cable to the Negative (-) weld output connection for MIG welding. If
welding with self shielded flux core, connect the ground cable to the Positive (+) weld output
connection and move the Weld Power Cable to the Negative (-) weld output connection.
1.6 Make certain the SPOOL GUN SELECTOR SWITCH on the front panel is switched into the
MIG TORCH position.
2. SPOOL GUN ASSEMBLY
2.1 This unit is set-up to accept the Quick Draw Spool gun only.
2.2 The Quick Draw Spool Gun has three connection points at the back of the spool gun. (1) The
gas connection is a slide on quick connector. (2) The weld power connection has a round ring
connection. (3) The trigger connection is the 5-Pin snap on connector.
Page of 26
9