Settings And Displays - Bosch TCA 58 series Operator's Manual

14
on Fill water tank 13, hold cup
P
+ flashing under foaming nozzle 9 and
J
turn dial 8 to
flashing Turn dial 8 to
J
on Turn dial 8 to
J
on Empty trays
I
flashing Trays missing
I
4 Coffee dispensing button
Coffee can be brewed by pressing this
button.
Press once for one cup. The coffee is
ground, brewed and dispensed into the cup.
Button flashes during this process.
4
Press twice within 3 seconds for two
cups. The coffee is ground, brewed and
dispensed into the cups (the grinding
and brewing process takes place twice).
Button flashes and
4
on the display during this process.
If the coffee dispensing button
i
pressed again, the coffee brewing
process is terminated.
5 Coffee strength button
This button is used to select the coffee
5
strength:
mild
5
medium
55
strong
555
The selected setting is shown on the
display.
6 Standby button
Button switches on the appliance or
a
switches it to stand­by mode. When button
is pressed, the appliance heats up and
a
button flashes while the appliance heats
a
up and is rinsed. When the buttons
and light up and one, two or three beans
h
(depending on the setting) appear on the
display, the appliance is ready for operation.
The appliance will not be rinsed if:
– it was still warm when switched on, or
– coffee was not discharged before it was
switched to "stand­by" mode.
Robert Bosch Hausgeräte GmbH
/ .
g h
/ .
g h
●
.
4
(2 cups) appears
6
is
4
5
a
,
4
7 Steam generation button
Button generates steam for foaming or
h
warming.
8 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to
steam, the button
(see "Preparing milk froth and hot milk").

Settings and displays

Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4. You can check the water
hardness using the enclosed test strip or by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1 1­7
2 8­15
3 16­23
4 24­30
● Determine the water hardness with the
enclosed test strip.
e.g.= Hardness 2
● Switch the device to stand­by.
● Hold down the steam button
least 5 seconds. The number of service
buttons
the selected water hardness.
● Press the steam button
, until the correct number of buttons is lit.
5 a
● Press button
number of service buttons should light
up briefly; this indicates that the desired
water hardness setting has been saved
successfully.
If a water filter (special accessory) is used,
the water hardness should be set to 1.
or . To dispense
g h
must be pressed first
h
1­13
14­27
28­42
43­54
, , , that light up indicate
4 5 a h
h
once. The selected
a
en
h
for at
h
repeatedly