Settings And Displays - Bosch TCA 56 series Operating Instructions Manual

14
on Service:
S
Descale/clean appliance
flashing S ervice programme
S
in operation
on Fill water tank 1, hold cup
9
+ flashing under nozzle 9 and turn
8
dial 8 to
flashing Turn dial 8 to
8
on Turn dial 8 to "O"
8
on Empty trays
D
flashing Trays missing
D
4 Coffee dispensing button
Coffee can be brewed by pressing this
button.
Press once for one cup. The coffee is
ground, brewed and dispensed into the cup.
Button flashes during this process.
4
Press twice within 3 seconds for two
cups. The coffee is ground, brewed and
dispensed into the cups (the grinding and
brewing process takes place twice). Button
flashes and (2 cups) appears on the
4 6
display during this process.
If the coffee dispensing button
i
pressed again, the coffee brewing process
is terminated.
5 Coffee strength button
This button is used to select the coffee
5
strength:
mild
5
medium
55
strong
555
The selected setting is shown on the
display.
6 eco button
The appliance can be put into "eco" mode
or returned to normal mode with the eco
button.
In "eco" mode the appliance consumes less
energy.
All displays and buttons are dimmed,
only messages such as "Empty trays" are
displayed in the usual brightness.
Robert Bosch Hausgeräte GmbH
/
g h
/
g h
4
is
4
5
The temperature of the cup shelf (warming
function) is lower.
Switching to "eco" mode starts an automatic
rinse cycle.
The appliance does not rinse if:
– no coffee was dispensed before it was
switched to "eco" mode.
– steam was dispensed shortly before it
was switched off.
Note: The appliance is programmed so
that it switches to "eco" mode automatically
after about 10 minutes. The default time can
be changed (see "Settings and displays").
7 Steam generation button
Button generates steam for foaming or
h
warming.
8 Steam dispensing dial
Hot water or steam can be dispensed by
turning the dial to hot water
To dispense steam, the steam generation
button must be pressed first (see "Steam
h
for foaming milk").

Settings and displays

Setting the water hardness
It is important that the water hardness be
set correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting is a water
hardness of 4. You can check the water
hardness using the enclosed test strip or by
asking your local water supplier.
Degree Water hardness
German (°dH) French (°fH)
1 1­7
2 8­15
3 16­23
4 24­30
● Determine the water hardness with the
enclosed test strip.
e.g. Hardness = 2
en
h
or steam .
g h
1­13
14­27
28­42
43­54