Preparing Milk Froth And Hot Milk; Maintenance And Cleaning - Bosch TCA 58 series Operator's Manual

en
Preparing milk froth
and hot milk
The appliance must be ready for use.

Risk of burns
!
The foaming nozzle 9 gets very hot. Hold it
by the plastic part only.
● Turn the rotary knob 9a to
milk or to heat the milk.
V
● Immerse tube 9f into a container with
enough milk.
● Press the button. It will start to flash.
h
The appliance will now heat up for
i
approx. 20 seconds.
● Place an appropriate cup under the
foaming nozzle 9.
● When the button lights up and
h
appears on the display, turn the dial 8 to
/ .
g h

Risk of scalding
!
When the dial is set to
may sputter a little. Escaping steam is very
hot and may cause liquids to sputter. Do
not touch the foaming nozzle 9 or aim it at
anyone.
● The milk is now drawn in and foamed or
heated.
● End the process by turning the dial 8
●
back to .
Note: When the foaming nozzle 9 has
cooled down, clean it immediately. Dried
residue is difficult to remove (see section
"Cleaning the foaming nozzle").
Tip: If possible, use cold low­fat milk
(1.5% fat).
Milk drinks such as hot chocolate can be
prepared using the
to foam the
W
J
/ the nozzle
g h
setting.
V

Maintenance and cleaning


Risk of electric shock
!
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
Daily cleaning
Each time the appliance is used, coffee
and milk residues accumulate. So the
fully automatic coffee machine should be
cleaned daily to remove them (preferably at
the end of the day).
● Clean the two coffee outlet nozzles 10
with a damp cloth.
● Wipe the outside of the appliance with a
damp cloth. Do not use scouring agents.
● Wash all removable parts by hand only.
● Rinse out the water tank 13 with water
only.
● Remove, empty and clean the trays for
coffee grounds 1 and residual water .
● Wipe out or vacuum the inside of the
appliance (tray holders).
Note: If the appliance is cold when switched
on with the
by after brewing coffee, it is automatically
rinsed, i.e. the system cleans itself.
Cleaning the foaming nozzle 9
Important: Clean the foaming nozzle 9
after each use.
● Immerse tube 9f into a container with
warm water.
● Place an appropriate container under the
foaming nozzle 9.
● Press the
The appliance will now heat up for
i
approx. 20 seconds.
● When the
appears on the display, turn the dial 8 to
/ .
g h
button, or if it is set to stand­
a
button. It will start to flash.
h
button lights up and
h
17
J
TCA58 06/2008