Silk'n Blue Instruction Manual
  1. Manuals
  2. Brands
  3. Silk'n Manuals
  4. Personal Care Products
  5. Blue
  6. Instruction manual

Silk'n Blue Instruction Manual

Hide thumbs Also See for Blue:
Table of Contents

Advertisement

Quick Links

Blue
TM
Instructions
for Use
1

Advertisement

Table of Contents
loading

Related Manuals for Silk'n Blue

Summary of Contents for Silk'n Blue

  • Page 1 Blue Instructions for Use...
  • Page 2 Quick Start: When you first open your Silk’n Blue™, charge the Blue batteries for the first time by plugging the Base Unit to electrical current and placing the Applicator in it for up to 6 hours. Before treatment the skin should be clean, dry and free of any powder, gel or cream.

  • Page 3: Table Of Contents

    First Steps with Silk’n Blue......................9 Silk’n Blue setup..............................9 Silk’n Blue battery charging........................9 Plan your Silk’n Blue treatment for best results................10 Treating with Silk’n Blue for the first time...................11 What to expect when treating with Silk’n Blue?................12 After treating with Silk’n Blue.........................12 Maintenance of Silk’n Blue......................13...

  • Page 4: Before You Start

    Before You Start Before using Silk’n Blue for the first time, please read this manual in its entirety. Pay particular attention to sections on device use procedures, device operation, and after-use procedures. What is Silk’n Blue? Silk’n Blue is a hand held light emitting diode (LED) device for Acne treatment.

  • Page 5: Package Contents

    Error - Charge the unit and try again Base Unit K (Orange) Battery Charging Adaptor L (Green) Battery Full Package contents Upon opening the Silk’n Blue package, you will find the following: Blue Base Unit and Applicator Adaptor User manual...

  • Page 6: Safety With Silk'n Blue

    When to avoid using Silk’n Blue? Certain conditions may temporarily prevent the use of Silk’n Blue. DO NOT USE Silk’n Blue if any of the following conditions apply to you: If you have eczema, psoriasis, lesions, open wounds or active infections, such as cold sores in the area to be treated.

  • Page 7: Possible Side Effects Using Blue

    • If the Applicator is damaged, make sure it is replaced with an original part from the manufacturer If you are unsure if Blue is safe for you to use, please consult with your doctor or dermatologist. Possible side effects using Silk’n Blue When used according to the instructions, side effects and complications associated with use of Silk’n Blue are rare.

  • Page 8: Protect Your Silk'n Blue

    • Store the device in a clean area free of dust. • Do not cover the ventilation slots during use. • Never shake or drop Silk’n Blue or subject it to severe shocks. • Silk’n Blue is sensitive to environmental temperature during use.

  • Page 9: Skin Treatment The Blue Way

    Silk’n Blue Setup 1. Remove Silk’n Blue Base Unit, Applicator, Adaptor and other components from box. 2. Before using the Silk’n Blue for the first time, fully charge the battery. This may take up to 6 hours. Silk’n Blue Battery Charging...

  • Page 10: Plan Your Silk'n Blue Treatment For Best Results

    When Battery – Charging - Indicator Light (K) turns off and Battery – Full - Indicator Light (L) illuminates, your Silk’n Blue is fully charged and ready to start. (Recharging will be needed when Ready Mode Indicator I (Green) is blinking) Plan your Silk’n Blue treatment for best results...

  • Page 11: Treating With Silk'n Blue For The First Time

    Treating with Silk’n Blue for the First Time The skin should be, clean, dry and free of any powder, gel or cream. Remove Silk’n Blue Applicator from its cradle in the Base Unit. Press the Power On/Off Switch. The green Ready/Treatment Indicator Light (I) will start blinking, and shortly afterwards will be lit steadily.

  • Page 12: What To Expect When Treating With Silk'n Blue

    What to expect when treating with Silk’n Blue? During a Silk’n Blue session it is normal to experience and feel: A Sensation of Warmth – During the Silk’n Blue session you may feel slight warmth. This is normal and should disappear up to an hour after the session.

  • Page 13: Maintenance Of Silk'n Blue

    • Store the clean device and all its parts in a dry place, at a temperature of between -10°C to 60°C / 14°F to 140°F To protect the environment At the end of its life, do not discard Silk’n Blue with the normal household waste. Dispose of it at an official recycling collection point.

  • Page 14: Removing The Rechargeable Batteries

    If you are unable to solve the problem with the informa- tion below, contact your local Silk’n Customer Service Center for further support. Problem Possible Cause Solution Silk’n Blue does not Charge the Applicator The rechargeable work batteries are empty Contact your local Silk’n Customer Service...
  • Page 15 Battery – Charging The ADAPTOR is Insert the Plug into the Base Unit Socket - Indicator Light not plugged in the (K Orange) does electrical outlet Connect another appliance to the wall not turn on when socket to check if the electrical outlet is live connecting the PLUG into the Base Unit Socket...

  • Page 16: Customer Service

    Customer Service For USA and Canada customers: For more information about Silk’n™ products please visit www.silkn.com. If your device is broken, damaged, in need of repair, or for any other user assistance, please contact Silk’n™ Customer Service: 1-877-DO-SILKN / 1-877-367-4556, contact@silkn.com For International Customers: For more information about Silk’n products or to find a list of International Silk’n websites please visit www.silkn.eu...

  • Page 17: Specifications

    Specifications Rated voltage (Adaptor) 100V - 240V Model: UE08WCP-105040SPA Rated frequency (Adaptor) 50Hz – 60Hz Rated Current (Adaptor) 400 mA Applied part Type BF Protecting rating IP20 (EN60529) Storage condition Temperature: -10°C to 60°C/14°F to 140°F Relative humidity: 5% to 95% Operating condition Temperature: 15°C to 35°C / 59°F to 95°F Relative humidity: 10% to 80%...

  • Page 18: Labeling

    Labeling Degree of protection against electric shock: type BF applied part WEEE - Waste Electrical and Electronic Equipment CSA Mark CE Mark Degree of protection against ingress water: ordinary This device is not suitable for use in the presence of flammable anesthetic mixture with air or with Oxygen or Nitrous Oxide.

  • Page 19: Français

    Brand Name Home Skinovations Model name Model Number Silk’n Blue AS1018321 Are fully in conformity with the essential requirements of EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC. This declaration is based on the full compliaance of the products with the following...
  • Page 20 Tavor Building, Shaar Yokneam POB 533 Yokneam 20692, ISRAEL tel. , fax +972-4-9097470 +972-4-9097471 info@silkn.com, contact@silkn.com www.silkn.com...

Table of Contents