Table of Contents
Advertisement
TG8202C_TG8231C_8232C(e).book Page 40 Friday, July 27, 2007 4:48 PM
Multi-unit Operation
To establish a conference call:
Press {CONF}.
L To leave the conference, press
{OFF}. The other parties can
continue the conversation.
Answering transferred calls
Press {C} to answer the page.
L After the paging party disconnects,
you can talk to the outside caller.
Transferring a call without speaking
to the other handset user
1
During an outside call, press
{TRANSFER}. i Press the
desired handset number.
L k flashes to indicate the outside
call is on hold.
2
{OFF}
L The outside call rings at the other
handset.
Note:
L If the other handset user does not
answer the call within 1 minute, the
call will ring at your handset again.
Registering a handset
to a base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base
unit (for example, w flashes even when
the handset is near the base unit),
register the handset.
1
{MENU} (centre of joystick) i *
i {SELECT}
2
{V}/{^}: "Registration" i
{SELECT}
3
{V}/{^}: "HS registration" i
{SELECT}
4
Base unit:
40
Proceed with the operation for your
model.
N KX-TG8202
Press and hold {x} (LOCATOR)
on the base unit for about 5
seconds. (No registration tone)
N KX-TG8231/KX-TG8232
Press and hold {x} (LOCATOR)
on the base unit for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start
ringing, press {x} (LOCATOR) to
stop, then repeat this step.
L After pressing {x} (LOCATOR),
the rest of this procedure must be
completed within 1 minute and 30
seconds.
5
Handset:
Press {OK}, then wait until a long
beep sounds and w stops flashing.
L When the handset has been
registered successfully, w will stop
flashing. If the key tone is turned
on (page 29), a confirmation tone
will be heard.
Deregistering a handset
A handset can cancel its own
registration (or the registration of
another handset) that is stored in the
base unit. This will allow the handset to
end its wireless connection with the
system.
1
{MENU} (centre of joystick) i *
i {SELECT}
2
{V}/{^}: "Registration" i
{SELECT}
3
{V}/{^}: "Deregistration" i
{SELECT}
4
{3}{3}{5} i {OK}
L The numbers of all handsets
registered to the base unit are
displayed.
Advertisement
Table of Contents
