Registering A Handset To A Base Unit - Panasonic KX-TGA660C Installation Manual

TGA660C(e).fm Page 4 Tuesday, December 14, 2010 11:27 AM
Charge for about 7 hours.
L When the batteries are fully charged, the charge indicator goes off and
"Fully charged" is displayed.
Rechargeable
Ni-MH ONLY
Note:
L When the language selection is displayed after installing the batteries
for the first time, you can select your desired language.
{r}: Select the desired setting. s {SAVE} s {OFF}
L If the batteries are fully charged, but the operating time seems to be
shorter, clean the battery ends (S, T) and the charge contacts with a
dry cloth and charge again.

Registering a handset to a base unit

1
Base unit:
N KX-TG4111 series
Press and hold {LOCATOR} for about 5 seconds. (No registration
tone)
N KX-TG4131/KX-TG6591/KX-TG6641/KX-TG6651/KX-TG7621
series
Press and hold {LOCATOR} for about 5 seconds until the
registration tone sounds.
L If all registered handsets start ringing, press {LOCATOR} again to
stop, then repeat this step.
2
Handset:
Place the handset on the base unit or charger, then wait until a long
beep sounds and w is displayed.
4
Charge indicator
Confirm
"Charging"
is displayed.