Final Setup For Operators; Safety Notes - Fetco CBS-2131XTS User Manual

Final Setup for Operators

1. Turn on incoming water supply line and carefully inspect both inside and
outside of the brewer for leaks in all fittings and tubes
2. Turn on power.
3. Press the brewer's main power switch (located on the lower right of the back
of the equipment)
4. The water tank will begin filling. FETCO Home Screen #1 will read
"FILLING".
5. When the water level rises and is sensed by the probe at the top of the tank
the heaters will activate
6. Heaters are automatically disabled until the tank is full.
7. While the water is heating Screen #2 "HEATING" will display and the actual
water temperature will be displayed.
8. After the water has reached the set temperature Screen #3 will display
"READY"
9. Review the Operating Instructions. Brew one full batch (water only) on each
side to confirm proper fill levels. The brewer is factory set with water only (no
coffee) to dispense the correct amount of water. If the actual volume is
slightly different from the programmed volume, fine tuning the brewer may be
necessary. See Calibrate Valves in the OUTPUT section in the
PROGRAMMING section.
10. Re-attach the covers after one final inspection for leaks. Look closely in the
top of the brewer section at the dispense fittings during this inspection.

Safety Notes

1. Professional installation is required. This appliance is manufactured only for commercial use .
2. Operation requirements and maintenance for commercial cooking appliances differ from household appliances.
3. Operators must be trained for this equipment and must understand the use, maintenance and hazards.
4. Access to the service area is restricted to persons having safety/hygiene knowledge and practical experience of the
coffee brewer. This appliance must be installed in locations where it can be overseen by adult trained personnel.
5. Do not attempt to move hot beverage equipment once it is filled. Drain equipment before moving.
6. FETCO commercial coffee brewers prepare large amounts of coffee or tea in a single batch using very hot water
7. Commercial coffee brewers provides very hot water from the sprayhead, brewbasket and faucet when it is pulled.
8. Coffee brewers may continue to dispense very hot water from the mechanically operated faucet after the electronic
touchpad is completely disabled by turning off the power switch on the lower back of the unit, or unplugging the unit.
9. For safety, the brewer control locks the brew basket for 5.5 minutes after starting the brew.
10. Do not attempt to defeat the factory set (default) time that the brew basket locked for safety from start of brew.
Keep these instructions for training and future reference
Final Setup
SCREENS SHOWN TO THE RIGHT WILL APPEAR
13
FETCO Home Screen #1 "FILLING"
XTS
™
CBS_2132 3L
EXTRACTOR
TOUCHSCREEN
Ready Touch
Heating screen
Filling to unlock™
Home Screen #2 "HEATING"
XTS
™
CBS_2132 3L
EXTRACTOR
TOUCHSCREEN
Ready
Tank Temp
197
Heating
Filling
™
FETCO Home Screen #3 "READY
XTS
™
CBS_2132 3L
EXTRACTOR
TOUCHSCREEN
Ready Touch
Heating screen
Filling to unlock™
°F