Table of Contents
Advertisement
TITLE
EXPERAID COMMAND LINE INTERFACE USER GUIDE
PROJECT
"DESKTOP RAID"
REV.
G–05-NOV-2007
3.3.4.3
Command Name
RebuildParity
Parameter 1
Array No.:
<Array=<1~4>>
Parameter 2
State setting:
<State=<Start:Stop>>
3.3.4.4
Command Name
VerifyParity
Parameter 1
Array No.:
<Array=<1~4>>
Parameter 2
State setting:
<State=<Start:Stop>>
3.3.4.5
Command Name
RefreshArray
Parameter 1
Array No.:
<Array=<1~4>>
Parameter 2
State setting:
<State=<Start:Stop:Pause>
>
5F, 38 TAIYUAN ST, JHUBEI, HSINCHU, TAIWAN, R.O.C.
Command Description
Use this command to rebuild parity of an array which contains parity.
i.e. RAID 5 or RAID 6.
Parameter Description
Array No.:
Specify an array number to rebuild parity.
Status setting:
Start or stop the parity rebuilding of the specified array.
Example
CLI>RebuildParity Array=1 State=Start [Enter]
Array 1 will start to rebuild parity if it exists and is configured as
RAID 5 or RAID 6.
Command Description
Use this command to verify parity of an array which contains parity.
i.e. RAID 5 or RAID 6
Parameter Description
Array No.:
Specify an array number to verify parity.
Status setting:
Start or stop the parity verification of the specified array.
Command Description
Use this command to refresh data of the specified array.
Parameter Description
Array No.:
Specify an array number to be refreshed.
State setting:
Start, stop the array refreshment or just pause the refreshment and
restart it with 'State=Start' parameter any time after it has been paused.
Example
CLI>RefreshArray Array=1 State=Start[Enter]
Array 1 will start to refresh data if it exists.
ACCUSYS, INC.
DOCUMENT STATUS
OFFICIAL RELEASE
PAGE 20 OF 27
Advertisement
Table of Contents
