Table of Contents
Advertisement
Figure 7.1.2 illustrates to add or edit configuration page.
Figure 7.1.2 Server or Interface configuration page.
The add or edit configuration page contains the following parameters.
Type: Server IP or interface list
Interface Name: Once the "type" drop down menu is changed to interface,
interface name selection drop down menu will appear for the users to make
selection on the interface where the DHCP server can be reach. The interface
also must include the interface where the client can be reach.
IP: Specify the IP address of the backend DHCP server.
Comments: Additional comments on this entry.
Active Enable or disable this entry.
"Apply" button to save any changes made. Please reboot to enable new
settings.
Example: How to setting DHCP Relay in the WAB-7400 Mesh AP?
1. Click "New Entry" button in the "DHCP Relay" page.
2. Select Type: "Interface", Interface Name: "VLAN0", Comments: "DHCP Server
MAC address", Active: "Enable" and then click "Apply".
3. Click "New Entry" button in the "DHCP Relay" page.
4. Select Type: "Server", Server IP: "DHCP Server IP address", Comments: "DHCP
Server MAC address" and then click "Apply" button.
5. When finished the steps then reboot the WAB-7400
41
Advertisement
Table of Contents
