Services; Service > Dhcp Relay - LevelOne WAB-7400 User Manual

Dual radio poe mesh access point

Hide thumbs Also See for WAB-7400:

Table of Contents

3.4 Services

3.4.1

Service > DHCP Relay

For a dynamic network, WAB-7400 is able to forward the DHCP request to a backend

DHCP server when operating in layer 2 mode. Figure 7.1.1 illustrates the

configuration page for DHCP Relay.

DHCP Relay contains the following parameters:

 Active: Enable or disable DHCP Relay feature.

 Port: Port to listen for DHCP packet. Default value is 67.

 Hop count: Number of hop the DHCP discover packet can travel before it is

dropped by this device. Default value is 10.

 Max packet size: Maximum packet size of the DHCP discover packet.

Normally specify a large number of packet size is recommended. Default

value is 1400.

 "Apply" button to save any changes made. Please reboot to enable new

settings.

 "Modify" button to edit current selection.

 "Remove" button to delete current selection.

 "New Entry" button to add server IP or Interface.

Figure 7.1.1 DHCP Relay Settings

Table of Contents