Attaching The Presser Foot Holder; Setting Up The Thread Spool Pins - Silvercrest SNMD 33 A1 Operation And Safety Notes

Attaching the presser foot holder

A
B
1
E
3

Setting up the thread spool pins

D
D
A
E
C
D
2
4
C
C
B
Attention:
Turn power switch to off ("O") when
carrying out any of the above operations!
1. Raise the presser bar (A) with the
presser foot lifter. Attach the presser foot
holder (B) as illustrated.
2. Attaching the presser foot
F
Lower the presser foot holder (B) using
the presser foot lifter, until the cut-out (C)
is directly above the pin (D)
The presser foot (F) will engage
automatically.
3. Removing the presser foot
Raise the presser foot using the presser
foot lifter.
Raise the lever (E) and the foot
G
disengages.
4. Attaching the edge/ quilt guide
Attach the edge/ quilt guide (G) in the
slot as illustrated.
Adjust as needed for hems, pleats,
quilting, etc.
The thread spool pins (C, D) serve to hold
the thread spools in place while thread is
being fed to the sewing machine. To use
the spool pin, pull it upwards. To store it,
push it down.
Note:
If you are using thread which tends to
wraps itself around the spool pin, put the
thread on the thread spool pin (C) and
lead the upper thread (A) through the
eye (B) in the thread spool pin (D), see
Fig. The eye (B) should point in the
direction of the thread spool.
Getting ready
GB / MT 11