Scallop Stitching; Twin Needle - Silvercrest SNMD 33 A1 Operation And Safety Notes

Scallop stitching

1

Twin needle

1
Stitch
This machine automatically produces a
scallop stitch which may be used as
decorative edging.
1. Sew the scallop stitch along the edge of
the material.
2. If desired, trim around the scallop with
scissors to create a scalloped edge. Be
careful not to cut the thread.
2
Stitch
Please note:
When sewing with twin needle, always
proceed slowly, and make sure to maintain
a low speed to insure quality stitching.
When using twin needle on zig-zag make
sure the stitch width dial is set between
"0" and "3". Do not use twin needle at
setting above "3".
Make sure that the two threads used to
thread the twin needle are of the same
h
weight. You can use one or two colors.
1. Place one felt cushion (h) and one spool
of thread (m) on the left thread spool pin
as usual.
2. Place another felt cushion (h) and
another spool of thread (m) on the right
thread spool pin.
3. Insert the twin needle in the same way
as single needle.
4. Flat side of needle should face away
from you.
5. Follow instructions for single needle
threading. Thread each needle
separately.
Sewing basics
Stitch width Stitch length
I 3~5
Stitch width Stitch length
A 2.5
1~2
1~4
GB / MT 23