Adjuste Presser Foot Pressure; Attaching The Presser Foot Holder - Silvercrest SNM 33 A1 Instruction Manual

a
b
1
e
3
Adjust presser foot pressure

Attaching the presser foot holder

e
d
2
4
The presser foot pressure of the machine
has been pre-set and requires no particular
readjustment according to the type of fabric
(light-or-heavy weight).
However, if you need to adjust the presser
foot pressure, turn the presser adjusting
screw with a coin.
For sewing very thin fabric, loosen the
pressure by turning the screw counter
clockwise, and for heavy fabric, tighten by
turning it clockwise.
Attention:
Turn power switch to off ("O") when
carrying out any of the above
operations!
1. Raise the presser bar (a) with the
c
presser foot lifter. Attach the presser
foot holder (b) as illustrated.
2. Attaching the presser foot
f
Lower the presser foot holder (b) using
the presser foot lifter, until the cut-out
(c) is directly above the pin (d)
The presser foot (f) will engage
automatically.
3. Removing the presser foot
Raise the presser foot using the
presser foot lifter.
Raise the lever (e) and the foot
g
disengages.
4. Attaching the edge/ quilting guide
Attach the edge/ quilting guide (g) in
the slot as illustrated.
Adjust as needed for hems, pleats,
quilting, etc.
6
Silver Crest SNM 33 A1