Troubleshooting; Please Read The Following Carefully - Central Pneumatic 95030 Set Up And Operating Instructions Manual

be more difficult and will take longer. Applying too much wax may also reduce
the life of the Foam Pad. If the Foam Pad continually comes off the 3" Pad (29)
during use, too much wax has been applied.
3. To clean the Polishing Kit:
cloth, using a mild detergent. Do not immerse the tool in liquids. The Foam Pad
(31) and Buffing Pad (32) may be washed and dried at medium heat.
4. When storing:
reach of children. Always remove the Foam Pad (31) and Buffing Pad (32) from
the Polisher when not in use. This will allow the pads to dry and retain their origi-
nal shape. To prolong the life of the pads, store the pads face up.
5. CAUTION!
must only be performed by a qualified service technician.
Problem
Polisher does not turn on when Trigger is
squeezed.
Foam Pad and/or Buffing Pad continually
comes off 3" Pad when tool is in use.
Releasing the Trigger on the Polisher does not
turn off the tool.

PLEASE REAd THE FOLLOWINg CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES
THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT
OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 95030 For technical questions, please call 1-800-444-3353.
Wipe the exterior of the Polisher with a clean, damp
Always store the Polishing Kit in a clean, dry, safe location out of
All maintenance, service, and repairs not mentioned in this manual

TROUBLESHOOTINg

Possible Solution
1. Firmly squeeze the Trigger.
2. Turn air compressor on and set its regulator to 90
PSI.
3. Secure all compressed air system connections
and make sure that there are no leaks.
4. Clean the air and oil filters in the air compressor.
5. Clean Air Filter within the Inlet Bushing of the
Polisher.
Thoroughly clean Pad. Thereafter, apply less wax to
Foam Pad.
Turn off the air compressor. Release any remaining
compressed air from the system and tool. Do not
use the tool until a qualified service technician repairs
the tool.
PAGE 8