Operation; Basic Operation; Sound Settings - Silvercrest SST 50 A1 Operating Instructions Manual

__DT53143_B6.book Seite 8 Dienstag, 24. August 2010 5:14 17

6. Operation

6.1 Basic operation

As a rule, the instructions describe opera-
tion with the remote control. You can also
use the buttons on the device to perform
the basic functions.
Switching the device on/off
1. Turn the power switch POWER 6 to
ON.
2. Press ON/STANDBY 11 on the device
or ON/STAND-BY 40 on the re-
mote control. The device starts with
the last selected settings (mode, sta-
tion and volume) and the brightest dis-
play lighting.
3. Press ON/STANDBY 11 on the device
or ON/STAND-BY 40 on the re-
mote control again to switch the de-
vice to standby mode.
The device remains in standby mode even
after it is switched off. Since the device
continues to use a little power in this mode,
switch off the device using the power
switch POWER 6 (OFF) if you are not us-
ing it for a prolonged period. You will then
need to reset the clock and alarm time as
well as any stored radio stations and

sound settings.

Selecting mode
With the device switched on, press
MODE 39 to choose between the various
modes. The following appears in the dis-
play:
- iPod
iPOD:
- Device connected via
AUX:
IN 9
- Radio
RADIO:
Display lighting
Choose between three brightness levels
for the display.
8
GB
• Press SNOOZE/DIMMER 30 to
change the display lighting. This will
not work if the alarm clock is currently
sounding.
Switching off with SLEEP
You can use the sleep function to specify a
time after which the device is to switch off.
1. Press SLEEP 34. A switch-off interval
flashes in the display.
2. Press SLEEP 34 repeatedly to specify
the switch-off interval (in minutes):
120, 90, 60, 45, 30, 15, 10, 05, 00
(off).
3. Once the switch-off interval has been
specified SLEEP appears in the dis-
play.
6.2 Sound settings
Volume
• Set the required volume with VOL +/
18 on the device or with VOLUME +/
31 on the remote control. The setting
is displayed (VOL 00 30) and stored
until the device is switched off at the
power switch POWER 6.
Muting
• Press 24 on the remote control to
switch the sound on and off.
Tone controls
Set the required tone with BASS +/ 33
and TREBLE +/ 32 on the remote control.
The setting is displayed (TREB, BASS: -05
to +05) and stored until the device is
switched off at the power switch
POWER 6.
AUX