Event - E-line ELI-ECO3-CVIM-4 User Manual

4.10.3 Event

4.10.3.1 Detect
In the main menu, from Setting->Event->Detect, you can see motion detect interface. See Figure
4-73.There is three detection types: motion detection, video loss, tampering.
The video loss has no detection region and sensitivity setup and tampering has no detection

region setup.
You can see motion detect icon if current channel has enabled motion detect alarm.

You can drag you mouse to set motion detect region. Please click OK button to save current

region setup. Right click mouse to exit current interface.
4.10.3.1.1 Motion Detect
After analysis video, system can generate a video loss alarm when the detected moving signal reached
the sensitivity you set here.
Detection menu is shown as below. See Figure 4-73.
Event type: From the dropdown list you can select motion detection type.

Channel: Select a channel from the dropdown list to set motion detect function.

Enable: Check the box here to enable motion detect function.

Region: Click select button, the interface is shown as in Figure 4-74. Here you can set motion

detection zone. There are four zones for you to set. Please select a zone first and then left drag the
mouse to select a zone. The corresponding color zone displays different detection zone. You can
click Fn button to switch between the arm mode and disarm mode. In arm mode, you can click the
direction buttons to move the green rectangle to set the motion detection zone. After you completed
the setup, please click ENTER button to exit current setup. Do remember click save button to save
current setup. If you click ESC button to exit the region setup interface system will not save your
zone setup.
Sensitivity: System supports 6 levels. The sixth level has the highest sensitivity.

Figure 4-72
129