E-line ELI-ECO3-CVIM-4 User Manual page 74

WIFI working status: Here you can view current connection status.

Please note:
After successful connection, you can see WIFI connection icon at the top right corner of the preview

interface.
When the hotspot verification type is WEP, system displays as AUTO since the device can not

detect its encryption type.
System does not support verification type WPA and WPA2. The display may become abnormal for

the verification type and encryption type.
After device successfully connected to the WIFI, you can view the hotspot name, IP address, subnet
mask, default gateway and etc.
4.10.2.4 3G
3G setup interface is shown as below. See Figure 4-58.
Please refer to the following contents for the parameter information.
Pane 1: Display 3G signal intensity after you enabled 3G function.

Pane 2: Display 3G module configuration information after you enabled 3G function.

Pane 3: Display 3G module status information after you enabled 3G function.

It is to display current wireless network signal intensity such as EVDO, CDMA1x, WCDMA, WCDMA,
EDGE and etc.
3G module: It is to display current wireless network adapter name.

3G Enable/Disable: Check the box here to enable 3G module.

Network type: There are various network types for different 3G network modules. You can select

according to your requirements.
APN: It is the wireless connection server. It is to set you access the wireless network via which

method.
AUTH: It is the authentication mode. It supports PAP/CHAP.

Dial number: Please input 3G network dialup number you got from your ISP.

User name: It is the user name for you to login the 3G network.

Password: It is the password for you to login the 3G network.

Pulse interval: You can set dialup duration. Once you disable the extra stream, the connection time

begins. For example, if you input 5 seconds here, then 3G network connection period is 5 seconds.
The device automatically disconnect when time is up. If there is no extra stream, 3G network
connection is valid all the time. If the alive time is 0, then the 3G network connection is valid all
the time.
Dial: Here you can enable or disable 3G network connection/disconnection manually.

3G wireless network: Here is to display wireless network status, SIM card status, dial status. If the

3G connection is OK, then you can see the device IP address the wireless network automatically
allocates.
117