Table of Contents
Advertisement
Available languages
Available languages
Fax +32 2 359 95 50
STEAM-IRONING
Fill the water tank with water and insert the mains plug into a wall socket.
As indicated on the temperature dial and in the table, steam ironing is only possible at
higher ironing temperatures, so set the dial to or .
Press the boiler power switch. The switch will light up and the pump pilot light will flash until
the required temperature is reached. Then it becomes steady.
Press the iron power switch and set the temperature dial of the iron to the desired position.
The iron power switch and the indicator lamp of the iron will light up. When the iron has
reached the desired temperature, its pilot light will go out. You can now use the steam
function.
Turn the steam control knob to regulate the amount of steam. Note: the maximal steam
rate ("MAX") can only be used when the ironing temperature is higher than position ,
or else water will drip from the sole.
Press the steam button to release steam from the soleplate of the iron. Release the button
and the steam will stop. If you want a continuous jet of steam, press the steam button
down and slide its purple top part backwards so that the steam button locks. To stop the
continuous jet of steam, push the purple part of the button forward again and release the
steam button.
When ironing, the pilot light of the iron will go on and off from time to time. This means that
the temperature of the iron is regulated by its thermostat. You can continue ironing.
When you use a lot of steam in a very short time, the steam output is lightly reduced until
your appliance produces enough steam to reduce the difference. This phenomenon also
happens when there is not enough water in the water tank.
When the water tank is running empty, the water refill indicator will come on. If you want
to go on using the steam function, you will have to refill the water tank. The water refill
indicator will go out when the water tank has been filled.
Note: when you start using the steam function, it is normal that the electrical pump makes
some vibrating sounds. This is due to the air inside the anti-calc cartridge and will lessen when
the air has been pumped out. If the noise has not diminished after 60 seconds, check if the
cartridge has been assembled correctly.
STEAMING IN A VERTICAL POSITION
Position the temperature dial on its maximum level for vertical steam ironing. The steam rate
can be adjusted according to your needs.
You have to hang the cloth you want to smooth out avoiding the creases and place the iron in
a vertical position at a few centimetres from the piece of cloth. Then move the iron and press
the burst of steam button at the same time.
DRY IRONING
Plug in the appliance and press the iron power switch.
Use the temperature dial to set the temperature needed.
When the indicator lamp of the iron goes out for the second time, you can start ironing.
For ironing without steam, leave the boiler power switch in OFF position and do not press
the steam button.
WHEN FINISHED IRONING
We recommend cleaning the iron after use as follows: fill the water tank, plug in the
appliance, press the boiler power switch and the iron power switch, put the temperature
dial on position "LINEN" and the steam regulator on MAX and let the iron heat for 10
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
13
Assembly page 13/64
TKG SIS 1002 - 130424
Advertisement
Table of Contents
