Wireless Remote Control - EuroLite NSF-350 User Manual

Wireless Remote Control

With the remote control it is possible to emit fog via radio over a distance of up to 25
meters.
1
The button has the same function as the button MANUAL FOG at the
control panel. Press the button to emit fog (continuous operation with 100 % fog
volume). The control LED lights.
2
To stop the fog output, press the button
Assigning the Remote Control
If the remote control working properly when taking the unit into operation, it either must be activated in menu
item "rEno" ( menu settings) or assigned to the unit. The remote control can be assigned during a short
period of time after switching on the machine as long as the following is indicated in the display:
To assign the remote control, press and hold both buttons until the display flashes repeatedly, to indicate a
match. This can take up to 12 seconds. Thus, the remote control has been assigned to the machine and may
be used for wireless control
Battery Change
If the range of the remote control decreases, the battery is probably exhausted and must be replaced. For
this purpose, take off the housing cover and remove the used battery. Insert a fresh 12 V battery, type 27A
as indicated in the battery compartment and refit the housing cover.
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and
should not be disposed of with regular domestic waste!
Notes Regarding Operation
1
All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when
installing your unit.
2
All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so
after being turned off.
3
All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
4
If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check
the fluid level, the external fuse, the thermo fuse and the power supply. If all of the above appears to be
ok, reconnect the unit again. If fog does not come out after holding the MANUAL FOG button for 30
seconds, check the tube attached to the tank to make sure there is fluid going through it. If you are
unable to determine the cause of the problem, do not simply continue pushing the button, as this may
damage the unit. Return the machine to your dealer.
www.eurolite.de
.
CAUTION!
26