Operation - EuroLite NSF-350 User Manual

6

OPERATION

The built-in control panel on the rear of the machine features four operating buttons and a display which
shows all operation statuses of the machine. The control panel allows the user to customize the color of the
LEDs, the DMX starting address, the fluid sensor and wireless remote control. The machine can be operated
manually with the button at the control panel or the remote control. Alternatively, it can be controlled with a
DMX controller. DMX control will take priority over the manual operation.
1
Switch the device on via the power switch. The display flashes and indicates "HEAT". At the same time,
the machine starts the warm-up process.
2
While the unit is warming up, fog output will not be possible yet. Program the necessary menu settings
with the control panel. Once the warm-up process is completed, fog output will be possible. The display
stops flashing.
3
After operation, switch off the machine with the power switch.
Manual Fog Output
To manually activate a fog output, press and hold the MANUAL FOG button at the control panel of the unit.
While this button is pressed, the unit will emit the maximum amount of fog. As soon as you release the
button, the fog output will stop.
The manual mode will take priority over the wireless remote control mode, i.e. when the button MANUAL
FOG is pressed, the unit will always emit the maximum amount of fog even if the wireless remote control
system is turned on in the menu settings.
During operation smoke emission may stop. In this case the device is heating up again, and
will be ready to operate in approx. 1 to 2 minutes. This process guarantees an appropriate
vaporization temperature and the best smoke emission possible. The temperature is
regulated by a high-quality thermostat.
The output nozzle will heat up during operation. Therefore do not touch the nozzle until it has
cooled down completely.
Prior to transportation, allow the machine to cool down and completely empty the tank.
Never operate the fog machine without fog fluid. Fire hazard due to overheating! Besides, the
unit may be damaged.
www.eurolite.de
25