Menu Settings; Menu Items; Operating Buttons; Operation Via Wireless Remote Control - EuroLite DYNAMIC FOG 1200 User Manual

Notes
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time no fog can be produced.
• If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check the fluid
level, the external fuse, the thermo fuse and the power supply. If all of the above appears to be ok, reconnect the
unit again. If fog does not come out after holding the MANUAL button for 30 seconds, check the tube attached to
the tank to make sure there is fluid going through it. If you are unable to determine the cause of the problem, do
not simply continue pushing the button, as this may damage the unit. Return the machine to your dealer.

Menu items

Display
Addr
rEПo
OrL

Operating buttons

Button
MENU
ENTER
▲/▼
With the remote control it is possible to emit fog via radio over a distance of up to 25 meters. For operation, put
the antennas at the fog machine and the remote control in a vertical position. When you hold down any of the four
trigger buttons, the fog machine will emit the maximum amount of fog. The control LED lights. As soon as you
release the button, the fog output will stop.
To set the remote control, press the button MENU until the display indicates "rEno". Then press ENTER to make
your settings. Use the buttons ▲ and ▼ to deactivate the remote control (indication "off") and to reactivate it
(indication "on"). Once again, press ENTER to confirm your settings.
Function
Setting the DMX address
Setting the wireless remote control
Setting the fluid sensor
Function
Selecting menu items
Editing menu items and confirming settings
Setting values

OPERATION VIA WIRELESS REMOTE CONTROL

MENU SETTINGS

21 • EN