Manual Fog Output; Wireless Remote Control (Accessory); Notes Regarding Operation - EuroLite NSF-100 User Manual

Manual fog output

To manually activate a fog output, press and hold the MANUAL FOG button at the control panel of the unit. While
this button is pressed, the unit will emit the maximum amount of fog. As soon as you release the button, the fog
output will stop.
Note
• The manual mode will take priority over the wireless remote control mode, i.e. when the button MANUAL FOG is
pressed, the unit will always emit the maximum amount of fog even if the wireless remote control system is
turned on in the menu settings.

Wireless remote control (accessory)

With the remote control it is possible to emit fog via radio over a distance of up to 25 meters.
• Connect the receiver part of the wireless remote control to the REMOTE CONTROL jack. As the base of the
receiver is magnetic, you can attach it to the fog machine.
• Make sure that the wireless remote control is enabled in menu item "rEno".
• The left button has the same function as the button MANUAL FOG at the control panel. Press the button to emit
fog (continuous operation with 100 % fog volume). The control LED lights.
• To stop the fog output, press the right button.
Note
• If the color menu is set to off, the machine will emit fog without activating the LEDs when using the remote
control.

Notes regarding operation

• All fog machines develop condensation around the output nozzle. Because this may result in some moisture
accumulation on the surface below the output nozzle, consider this condensation when installing your unit.
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or so after
being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a short
period in order to heat up again. During this time no fog can be produced.
• Please note that this machine is not a light effect. Permanent operation of the LEDs without fog output is not
recommended as it might damage the LEDs.
• If you experience low output, pump noise or no output at all, disconnect from mains immediately. Check the fluid
level, the external fuse, the thermo fuse and the power supply. If all of the above appears to be ok, reconnect the
unit again. If fog does not come out after holding the MANUAL FOG button for 30 seconds, check the tube
attached to the tank to make sure there is fluid going through it. If you are unable to determine the cause of the
problem, do not simply continue pushing the button, as this may damage the unit. Return the machine to your
dealer.
20 • EN