Hardware Installation - TRENDnet TPE-S44 Quick Installation Manual

3. Hardware Installation

Note: The maximum amount of PoE power available is 15.4 Watts per port and 30 Watts total. If a power
overload has occurred, the switch will prioritize the distribution of power by port (from lowest to highest).
That is, port 1 will receive the highest priority and port 4 will receive the lowest priority. The ports with lower
priority will have their PoE function disabled until more than 7.5 watts of power becomes available.
1. Plug the power cord into the Power Adapter. Connect the Power Adapter to the TPE-S44 and then to
a power outlet.
2. Connect an RJ-45 network cable from the TPE-S44 to your computer's network port.
3. Connect an RJ-45 cable from a port (1-4) on the TPE-S44 to the Network port of the PoE device
(e.g. TV-IP310PI).
4. Verify the following LEDs are on: Power, PoE Status and Link/ACT.
2
POE
PoE
2
1
3