Advertisement
7
Carefully lift the fan motor assembly
and engage the slot in the motor
housing with the hook on the mount-
ing plate so that the motor is secure-
ly suspended.
10
Loosen the two screws and washers
across from each other on the ridge
of the mounting plate. Remove the
other two screws and lock washers.
Save for later use.
13
Check the motor for shipping stabi-
lizers and remove if present. Attach
blades using screws and washers in
hardware pak. Tighten screws
securely.
16
Connect plug from fan to switch
house plug.
8
Connect black and blue wire from fan to Black
or (Hot) wire from house. Connect White wire
from Fan to White (Neutral) wire from house.
Connect Ground leads from mounting bracket
and downrod to Ground lead from house.
Refer to Safety Tips section of manual.
11
Lift the motor housing up aligning the L
shape holes with the screws and
washers on the mounting plate. Turn the
housing clockwise to hold in position.
Install the other two screws and washers
previously removed securely.
14
Loosen 2 screws and remove 1 screw
from motor plate. Save removed
screw for use later.
17
Loosen the pre installed screws of
switch housing plate.
9
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
12
Lift the decorative ring up and twist clock-
wise till tight.
15
Install by twisting clockwise, add 1
screw removed step 14 to switch
housing plate. Tighten the 3 screws
securely.
18
Connect white wire from fan to white
wire from light fixture. Then plug
blue wire from fan to black wire from
light fixture.
Advertisement
