Kenmore 790.7804 Use & Care Manual page 34

Care & Cleaning
Replacing the Round Halogen Oven Light
The round halogen oven light is located in the upper oven, at the
rear of the oven cavity and is covered with a glass shield held
by a wire holder (Figure 54). The glass shield protects the light
bulb and must be in place whenever the oven is in use
(Figure 55).
To replace the upper oven round halogen light:
Be sure the range is unplugged and all parts
are cool before replacing oven light. Wear a leather-faced
glove for protection against possible broken glass.
1. Turn electrical power off at the main source.
2. Remove light shield by turning a quarter turn counter-
clockwise (Figure 55).
3. Replace bulb with a new T-4 type Halogen 25 watt
appliance bulb.
Important: Do not allow your fingers to touch the new bulb when
replacing. This will shorten the life of the bulb. Use a paper
towel or cotton glove while handling the new bulb when
installing.
4. Replace glass shield by rotating clockwise. The glass shield
must be in place whenever the oven is in use.
5. Turn power back on again at the main source (or plug the
appliance back in).
6. The clock will then need to be reset. To reset, see
Timer" on page 15.
Figure 54: Upper oven round halogen light
Figure 55: Replacing the upper oven round halogen light
Replacing the Rectangle Halogen Oven Light
The rectangle halogen oven light is located in the lower oven
and will turn on automatically when the oven door is opened.
The oven light may be turned on when the door is closed by
pressing LIGHT on the control panel.
Important: The lamp is covered with a glass shield. The glass
shield can be removed to be cleaned manually or to change the
oven light.
To replace the lower oven rectangle halogen light:
are cool before replacing oven light. Wear a leather-faced
glove for protection against possible broken glass.
1. Turn power off at the main source or unplug the appliance.
2. To remove the glass shield, pull the back side of the shield
toward the inside of the oven in a manner to lift it up from
the oven side. The glass shield should come out easily by
pushing a little toward front of the oven
3. Replace bulb with a new T-4 type Halogen 25 watt
appliance bulb.
Important: Do not allow your fingers to touch the new bulb when
replacing. This will shorten the life of the bulb. Use a paper
towel or cotton glove while handling the new bulb when
installing.
4. Replace glass shield oven the bulb. The glass shield must be
"Setting
in place whenever the oven is in use.
5. Turn power back on again at the main source (or plug the
appliance back in).
6. The clock will then need to be reset. To reset, see
Timer"
Figure 56: Lower oven halogen light glass shield
Figure 57: Lower oven halogen light bulb
34
Be sure the range is unplugged and all parts
on page 15.
Lift backside of
glass shield and
remove it.
Halogen
Light Bulb
(Figure 56).
"Setting