Kenmore 790.7804 Use & Care Manual page 29

3. Press START. DOOR and LOCKED will flash. The CLEAN
icon and letters CLn will remain in the display.
4. As soon as Self Clean becomes active, a motor driven lock
mechanism will begin locking the oven door automatically.
Once the door has been locked, DOOR and LOCKED will
stop flashing and remain on. Also, the oven icon will appear
in the display. Allow about 15 seconds for the oven door to
lock.
Important: If the optional delay Self-Cleaning cycle is desired,
continue and finish these steps. But if Self Clean is started imme-
diately, skip these remaining steps and continue to the When
Self Clean is Finished-portion of these instructions.
5. Press Delay Start (Figure
Figure 49: Display for using Delay Start with Self Clean
6. Enter the desired start time, using 4 3 0
Figure 50: Entering Delay Start start time
7. Press START. CLEAN, DELAY, LOCKED, and DOOR will be
displayed (Figure 51).
Figure 51: CLEAN, DELAY, LOCKED, and DOOR in display
8. The control will start the self-cleaning at the set start time,
for the period of time previously selected. At that time, the
DELAY will go out.
49).
(Figure 50).
When Self Clean is finished:
Use caution when opening the oven door after
self cleaning. The oven may still be very hot and can cause
burns. To avoid possible burns, stand to the side of the oven
when opening the oven door to allow hot air or steam to escape.
The oven interior may appear to have cooled after it has been
turned off. The oven may still be hot, and burns may occur if it is
touched before it has cooled.
Do not force the oven door open when self-
clean is active. This can damage the automatic door-locking
system. Use caution when opening the door after self-clean
cycle is complete; the oven may still be very hot.
1. Hot will appear in display. The time of day, DOOR,
LOCKED, and CLEAN icons will remain in the display.
2. Once the oven has cooled down (about 1 hour), and DOOR
and LOCKED icons are no longer displayed, the oven door
can then be opened.
3. When the oven interior has completely cooled, wipe away
any residue or powdered ash with a damp cloth or paper
towel.
Important note:
• The kitchen area should be well ventilated. Use an open
window, ventilation fan, or exhaust hood during the first self
clean cycle to help eliminate the normal odors associated
the initial clean cycle.
• When the clean time finishes, the oven door will remain
locked until the oven has cooled sufficiently. In addition to
the clean time that was programmed, allow about 1 hour for
the oven to cool before opening the oven door. The Self
Clean function will not operate when the oven lockout is
active.
29
Oven Controls