Batch; Add; Enter Key; Print Key - Talaris ntegra 177-0800 User Manual

Operating / Set-up Instructions
3.8.3

BATCH

Press the BATCH key to place the Ntegra in batch counting mode. The required
batch quantity may be specified using the numeric keys, followed by the ENTER
key.
When in a value counting mode ( Single, Mixed, Face, Orient, Serial, Fit ), a
second press of the BATCH key will place the Ntegra in a 'value' batching mode.
The required value may be specified using the numeric keys, followed by the

ENTER key.

3.8.4

ADD

Press the ADD key to place the Ntegra in a count adding mode. At the end of a
count, press the PRINT key to add the count or value to the Grand Total.
Consecutive bundles of notes will be totalled.
3.9 Enter Key
The Enter ( Start/Stop ) key is used to enter data into the Ntegra memory in
specific Supervisor Set-up features.
The Enter key acts to start and stop the Ntegra when operating in 'Manual' mode.
1
3.10

Print Key

If an Integral or external printer is fitted and enabled, pressing the PRINT key at
the end of a count will transmit the count data to the printer.
If the Ntegra is operating in the ADD mode, pressing the PRINT key will transfer
the count to the Grand Total, and if an Integral or external printer is fitted and
enabled, transmit the last count to the printer.
The PRINT key will NOT function in the following conditions:
1 When the counted notes have been removed from the stacker.
2 When notes are present in the reject pocket.
3 When notes remain in the input hopper.
4 While a count is in progress.
Page 16 of 56
Copyright © 2009 by Talaris Ltd., Basingstoke (UK)
Note:
Ntegra
TP05413021 Interim