Preparing For Use; Placing The Electric Underblanket; Switching On / Off; Operation - Silvercrest B69PF Operating Instructions Manual

fault and must be sent to the service centre ad-
dress given below.

Preparing for use

Placing the electric
underblanket
Starting at the foot end, spread out the electric
underblanket over the mattress so that the plug-
in connector is approximately at the level of
7
the shoulders (see Fig. B).
Note: The area of the head is not heated.
Guide the mains plug of the plug-in connector
through the slot in the side part
connect the control unit
derblanket by plugging the two parts of the plug-
in connector together (see Figs. B and C).
7
Then pull the side part as you would a fitted sheet
over the sides of your mattress. The electric
underblanket is designed so that it fits 90 x
190 cm mattresses.
Then place the bottom sheet as usual over the
electric underblanket, so that the electric under-
blanket lies between the mattress and the bot-
tom sheet.
Ensure that the electric underblanket is completely
flat and that it does not become drawn together
or folded during use.

Switching on / off

Switching on:
Press the ON / OFF switch
unit to switch on the electric underblanket.
1
When switched on, the display
and shows all its segments for approx. 3 seconds.
Then the display
setting:
Temperature setting for the body zone: 0
Automatic switch-off time: 1h (= 1 hour)
Temperature setting for the foot zone: 0
66378_silv_Waermeunterbett_Content_LB6.indd 9
Safety system / Preparing for use / Operation
and then
8
to the electric un-
1
on the control
4
illuminates
2
shows the following basic
2
Switching off:
Press the ON / OFF switch
unit to switch off the electric underblanket.
1
When switched off, the light and the display
cease to illuminate.

Operation

Setting the temperature

Press the button for setting the temperature of
the body zone
6
Press the button for setting the temperature of
the foot zone
7 3
Setting 0: OFF
Setting 1: Minimum heat
Settings 2–8: Customised heat
Setting 9: Maximum heat
Note: Switching sequence of the temperature
settings: 0–9–8–7–6–5–4–3–2–1–0–9 ...

Selecting the temperature

Note: This electric underblanket has a rapid
heat-up feature.
Switch the electric underblanket on approxi-
mately 30 minutes before going to bed and
cover it with the top sheet and other bedding.
By doing this you will keep all the heat in.
Set the control unit to the highest temperature
setting (setting 9). This will cause the electric
underblanket to warm up quickest.
For use over several hours, set the control unit
to the lowest temperature setting (setting 1)
1
for the body and the foot zones.
Note: This electric underblanket has an automatic
switch down feature. After a period of approx. 3
hours at temperature settings 9, 8 or 7, the electric
underblanket automatically switches down to set-
ting 6.
on the control
4
.
.
GB/IE
15.06.11 10:03
2
9