Advertisement
Available languages
Available languages
Low: Use to simmer foods, keep foods
warm and malt chocolate or butter. Some
cooking may take place on the Low
setting if the pan is covered.
High: Use to bring liquid to a boil, or reach
pressure in a pressure cooker. Always
reduce setting to a lower heat when liquids
begin to boil or foods begin to cook.
Med: An intermediate flame size is used to
continue cooking. Food will not cook any
faster when a higher flame setting is used
than needed to maintain a gentb boil.
Water boils at the same temperature
whether boiling gendy or vigorously.
Surface
Controls
• If flame should go out during a cooking operation, turn
the burner off. If a strong gas odor is detected, open a
window and wait five minutes uefore relighting the
burner
- Be s_re all surface controls are set in the OFF position
prior to supplying gas to the range.
- NEVER touch cooktop until it has cooled. Expec_some
parts of the cooktop, especiaii} around the burners, to
become warm or hot during cooking. Use potholders to
Pilotless ignition
(selectmodels)
Pilotless ignition ehlinates the need for a constant standing
pilot light. Each sealed burner has a spark ignitor. There are
two ignitors for conventional surface burners. When cleaning
around the surface burner use care. If cleaning cloth should
catch the ignitor, it could be damaged, preventing ignition.
If the surface burner does not
light, check if ignitor is
__N_.EAO
broken, soiled or wet. If
/t/
///Xt,"
clogged, dean tile
_ _,,
"
_ X
small port beneath
(_ _
_ _#k
-1
tile ignitor
PORTB
/
using a
_.
straight
pin.
_
NIGNITOR
PORT BELOW IGNITOR
Pimot ignition
(selectmodels)
When the range is first installed, the standing pilots may be
difficult to light due to air in the gas line. To bleed off air from
the line, hold a lighted match next to the burner and turn the
knob on. When the burner lights, turn the knob off and
proceed as directed below.
To light
pilot:
Raise the cooktop and hold a
lighted match near the pilot
ports (:Seeillustration}. There
are two pilot ports, one on the
right side and one on the left
side.
Surface
Control Knobs
Use to turn on the surface burners= An infinite choice of heat
settings is available from Low to High. At the High setting a
detent or notch may be felt. The knobs can be set on or
between any of the settings.
0
0
Graphics next to the knob identify which burner the
knob controls. For example, the graphic at left shows
0
the left front burner location.
Setting
the controls:
The size and type of cookware will affect the heat setting. For
information on cookware and other factors affecting heat
settings, refer to "Cooking
Made Simple" booklet.
1. Place a pan on the burner grate.
" The burner flame may lift off or appear separated from
the port if a pan is not placed on the grate.
2. Push in and turn the knob counterclockwise to the Lite
setting.
" A ciicking (spark} sound wiii be heard and the burner
wiii iighL (Aii ignitors wiii spark when any surface
burner knob is turned to the Lite position.}
3. After the burner lights, turn knob to desired flame size.
The ignitor wiii continue to spark until the knob is
turned past the Lite position.
5
Advertisement
