Euphonix Max Air Manual page 41

Euphonix Max Air Installation Guide

13
TCC Extension Port (DC-62, optional): Connect a second TCC breakout cable to this port
to
connect up to four additional ML530 Mic/Line Interfaces.

14
SNMP Serial Port (DE-9): This port is used to configure the SNMP card via another
computer.

15
TT002 (75-ohm BNC, DE-9 female, DE-9 male): BNC port is for Bi/Tri-Level Video
input; DE-9 female is for RS422 (Sony 9-pin); DE-9 male is for Midi Machine Control
and Time Code I/O (via breakout cable).

16
GPIO Port 1 (DC-37): GP Inputs and Outputs 1 to 16.

17
GPIO Port 2 (DC-37): GP Inputs and Outputs 17 to 32.
Connect the machine room KVM extender (transmitter end) to the VGA, keyboard, and
mouse connectors to the rear panel of the SC263. A second KVM extender (receiver end)
should be installed at the control surface, close to where the Emix monitor, keyboard and
mouse are to be located. The KVM extenders are connected by a single CAT5 cable built
into the console ethernet harness (provided).
NOTE: SC263 rear connector configurations are subject to change.
41
System 5 Components