ECS GeForce 6100PM-M2 Manual page 48

42
SuperIO Device (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Onboard FDC Controller
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x
ECP Mode Use DMA
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
Onboard FDC Controller (Enabled)
This option enables the onboard floppy disk drive controller.
Onboard Serial Port 1 (3F8/IRQ4)
This option is used to assign the I/O address and interrupt request (IRQ) for onboard
serial port 1.
Onboard Parallel Port (378/IRQ7)
This item enables or disables the onboard parallel port, and assigns a port address. The
Auto setting will detect the available address.
Parallel Port Mode (SPP)
Use this item to select the parallel port mode. You can select Normal (Standard
Parallel Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or
BPP (Bi-Directional Parallel Port).
•
ECP Mode Use DMA (3): When the onboard parallel port is set to ECP
mode, the parallel port can use DMA3/1.
Press <Esc> to return to the Integrated Peripherals page.
Phoenix-Award WorkstationBIOS CMOS Setup Utility
Super IO Device
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
F6: Fail-Safe Defaults
Using BIOS
Item Help
Menu Level
F7:Optimized Defaults