Pace DC511P Operator's Manual page 7

SAFETY INFORMATION (cont.)
Safety check
Upon completion of any servicing or repairs to your set-top, ask the
service technician to perform safety checks to determine that your
set-top is in its proper operating condition. See also item 14 in the
Important Safety Instructions.
SAVE THIS INFORMATION FOR FUTURE REFERENCE
The POWER OUTLET plug is designed only for connection to the AC
power cord for a TV. The maximum power it can supply is 500 watts.
Do not connect any equipment that uses more than 500 watts, or any
non-TV equipment such as a toaster or hair drier.
POWER OUTLET for TV only
120V AC 60Hz 4.2A max.
POWER INPUT
120V AC 60Hz 0.5A max. exc. outlet
120V AC 60Hz 4.7A max. inc. outlet
DOUBLE INSULATED
POWER INPUT
6
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO RECEIVE
OVER-THE-AIR BROADCAST SIGNALS.
CONNECTION OF THIS DEVICE IN ANY OTHER
FASHION MAY CAUSE HARMFUL CABLE IN
INTERFERENCE TO RADIO COMMUNICATIONS
AND IS IN VIOLATION OF THE FCC RULES,
PART 15.
BYPASS
9V DC
100mA max.
The CABLE IN connector is designed for
connection to a cable network only.
You must not connect any other equipment,
such as a VCR, to this input.
Safety aspects of connections
Full details of the rear panel are on page 8.
Connecting
Do not connect your set-top (or any other equipment such as a TV
or VCR) to the power supply until you have properly connected all
the other cables.
Your set-top operates with a 120 V AC, 60 Hz power supply. Do
not connect your set-top to any supply other than this.
This set-top is equipped with a two-wire power cord, with a
polarized plug at one end. The other end of the cord is fitted with
a polarized connector, which is shaped such that it can only be fitted
one way into the power input jack of your set-top. Connect this
end first, before inserting the polarized plug into the wall socket-
outlet.
Disconnecting
TO TV
Disconnect your set-top from the power supply before you
disconnect any other equipment from its rear panel.
The only way to disconnect your set-top from the power supply is
to remove the power cord from the wall socket-outlet. Your set-
top must therefore be installed near to the wall socket-outlet,
which should be easily accessible.