Pace DC511P Operator's Manual page 10

POWER OUTLET Connect the TV's power cord here to provide AC power to your TV.
POWER INPUT Connect your set-top's power cord here.
CABLE IN Connect the incoming cable service here. The optional RF-bypass module also
connects here.
BYPASS Connect an optional (but not supplied) RF-bypass module here, so that it can
receive its power from your set-top.
TO TV Connect to the antenna/cable input on your TV or VCR
VIDEO OUT Connect to the video baseband input on your TV or VCR.
S-VIDEO OUT Connect to the S-video baseband input (if present) on your TV or VCR.
AUDIO OUT Connect to the stereo audio inputs on your stereo TV, stereo VCR, optional
stereo amplifier or home theater receiver
DIGITAL AUDIO OUT Connect to the electrical digital audio input (electrical S/PDIF) on optional
digital audio equipment, such as an audio decoder or home theater receiver.
VIDEO IN Connect to the video baseband output on your DVD player (or similar).
AUDIO IN Connect to the stereo audio outputs on your DVD player (or similar).
IR TRANSMIT Connect to an optional (but not supplied) VCR controller. (IR transmitter).
IR RECEIVE Connect to an optional (but not supplied) "remote eye" (IR receiver).
REAR PANEL (cont.)
WARNINGS
Do not connect your set-top (or
any other equipment such as a TV
or VCR) to the AC power supply
until you have properly connected
all the other cables.
Disconnect your set-top from the
AC power supply before you
disconnect any other equipment
from its rear panel.
The power outlet is designed only for
connection to the AC power cord for
a TV. The maximum power it can
supply is 500 watts. Do not connect
any equipment that uses more than
500 watts, or any non-TV equipment
such as a toaster or hair dryer.
The cable input is designed for
connection to a cable network only.
You must not connect any other
equipment, such as a VCR, to this
input.
Any cable connected to DIGITAL
AUDIO jacks must be 75 ohm
coaxial, not regular audio cable.
9