Pace DC511P Operator's Manual page 21

SOLVING PROBLEMS (cont.)
Check
Is there any sound?
YES
Can you see and hear a
DVD that you are
trying to play?
YES
Can you see only
regular (analog)
channels but not any
digital channels?
20
Suggested solution
Check that the audio cables are securely
NO
and correctly connected.
For the signal to loop through your set-
NO
top from a DVD (or similar equipment)
to reach your TV, you must activate
baseband loopthrough by turning off
your set-top.
The RF-bypass feature may be turned on.
YES
Press the BYPASS button on your
remote control to turn the feature OFF
(make sure the word BYPASS is not
lighted on the front panel).
Further checks, if there is still a problem
Check that you have not muted the sound on your
set-top, TV and/or any attached audio equipment.
Adjust the volume control on your set-top and/or
TV.
If you can hear only mono sound, first check that
the program is likely to have stereo sound (an old
movie, for example, may not be in stereo).
Check that all the audio and video cables are
securely and correctly connected, including any to a
home theater receiver that you may be using to
enhance the sound.