Table of Contents
Advertisement
Status LEDs and Buttons
Table 3-2
Rear-Panel LED States (continued)
LED Name
9
1-Gb (dedicated management)
Ethernet link speed
10 1-Gb (dedicated management)
Ethernet link status
11 Not used at this time
12 Not used at this time
13 Not used at this time
14 Cisco IMC (service processor)
status
15 Drive expander module status
LED
16 10-Gb Ethernet link speed
(only when dual 10 Gb adapter
card is installed)
17 10-Gb Ethernet link status
(only when dual 10 Gb adapter
card is installed)
18 Power supply status
19 Port not used at this time
Table 3-3
Drive Expander Module Status LED
P3V3
P5V
Off
None
On
On
On
Fail
On
On
On
On
Cisco UCS C3160 Rack Server Installation and Service Guide
3-6
State
•
Off—Link speed is 10/100 Mbps.
Green—Link speed is 1 Gbps.
•
Off—No link is present.
•
Green—Link is active.
•
Green, blinking—Traffic is present on the active link.
•
•
•
•
Off—Cisco IMC is working correctly.
•
Green—Cisco IMC is not ready.
•
This LED can indicate failure of an installed drive or a failure of the module. See
Table 3-3
for LED interpretations.
•
Off—Link speed is 10/100 Mbps.
•
Amber—Link speed is 1 Gbps.
•
Green—Link speed is 10 Gbps.
Off—No link is present.
•
Green—Link is active.
•
Green, blinking—Traffic is present on the active link.
•
Off—No AC power input.
•
Green, steady—The power supply is operating normally and supplying DC
•
power to the system.
Green, blinking—AC power is OK, DC output not enabled (sleep mode).
•
Amber, blinking—An event warning threshold has been reached, but the power
•
supply continues to operate.
Amber, steady—A critical fault threshold has been reached, causing the power
•
supply to shut down.
•
HDD Present HDD Status
None
None
No plug-in
None
No plug-in
None
Plug-in
Good
Plug-in
Fail
LED Status
Off
Amber
Amber
Green
Amber
Chapter 3
Maintaining the System
OL-32062-01
Advertisement
Table of Contents
