Sharp MX-M260 Online Manual page 6

1 PRINT
Basic printing
5
Click the "Print" button.
Printing begins.
●
The output tray can be selected in the system settings
Note
(administrator) (see "OUTPUT TRAYS" in the
"SYSTEM SETTINGS (ADMINISTRATOR)" in the
operation manual).
●
The output tray can also be selected in the print
settings at the time of printing. To change the tray
selection, select the desired tray in "Output" in the
"Paper" tab of the printer driver setup screen.
● Printing can be canceled in the job status screen.
☞
Canceling a print job
● If the paper type setting in the printer driver is different
from the bypass tray's paper type setting in the
machine, printing may stop. To resume printing, press
the [PRINT] key on the operation panel, touch the
[BYPASS TRAY] key in the touch panel, and specify
the same paper type as in the printer driver.
CO NT E N TS
When "Paper Selection" is set to "Auto Select"
If "Paper Selection" is set to "Auto Select" in the "Paper" tab of the
printer driver setup screen and the correct size of paper for a print
job is not loaded in the machine, the printing procedure will vary
depending on the "FORCED OUTPUT OF PRINT" setting in the
system settings (administrator) (see the "SYSTEM SETTINGS
(ADMINISTRATOR)" in the operation manual).
When "FORCED OUTPUT OF PRINT" is disabled
If the bypass tray can be used, a message prompting you to
print from the bypass tray will appear in the touch panel.
Press the [PRINT] key on the operation panel, touch the
[BYPASS TRAY] key, load paper in the bypass tray, and then
touch the [BYPASS] key. Printing will begin automatically.
When "FORCED OUTPUT OF PRINT" is enabled
Printing will take place using a size of paper that is close to the
size of the print image.
If the paper is loaded in a different orientation than the
Note
print image, the image is automatically rotated to match
the paper. This setting can be changed in the system
settings (administrator) (see "ROTATED PRINT" in the
"SYSTEM SETTINGS (ADMINISTRATOR)" in the
operation manual).
(part 2)
6