Installation; Electrical Requirements; Adjusting The Feet - Maytag MDC1305AAW Instruction Book

Condenser tumble dryer reverse action
Table of Contents

Advertisement

40002643.qxd
03/03/2005

Installation

If the mains cord
on this appliance
is damaged, it
must be replaced
by a special cord
which is ONLY
obtainable from
the Maytag spares
service. It must be
installed by a
competent person.
If this appliance is
supplied from a
cord extension set
or electrical
portable outlet
device, the cord
set or electrical
portable outlet
device must be
positioned so that
it is not subject to
splashing or
ingress of
moisture.
6
19:42
Page 6

Electrical requirements

Tumble dryers are supplied to operate at a
voltage of 230V, 50 Hz. Check that the supply
circuit is rated to at least 10A.
Electricity can be extremely dangerous.
This appliance must be earthed.
The socket outlet and the plug on the appliance
must be of the same type.
Do not use multiple plug adapters.
The plug should be accessible for disconnection
after the appliance has been installed.
The wires in the mains lead are coloured in
accordance with the following codes:
Blue
Brown
Green and Yellow
Do not plug the machine in and switch
it on at the mains until the installation is
For your safety, this dryer must be
If there is any doubt about installation,
call Maytag Service for advice.

Adjusting the feet

Once the machine is in place the feet should be
adjusted to ensure that the machine is level.
Adjust the four feet to ensure the machine is firm
and level.
NEUTRAL
LIVE
EARTH
completed.
correctly installed.

Advertisement

Table of Contents
loading

Table of Contents