Setup Instructions; General User Information - Maytag W10165327A Installation & Setup Instructions Manual

This washer can hold up to a 16 lb (7 kg) load of laundry.
1. PD Models: Insert coins until "SELECT CYCLE" flashes in display.
PR Models: A debit card is required rather than coins. In Enhanced Debit mode, the card
balance will also display when a debit card is inserted into the reader.
2. Door must be closed before cycle selection is made,
3. Press fabric setting keypad for the wash cycle desired. After the cycle is started, the time
will display and count down.
4. When a cycle is interrupted by opening the door, "RESELECT CYCLE" will flash in the
display. To restart the washer, close door and press any key.

General User Information

"- - - -" INOPERATIVE STATE - These lines on the display indicate the appliance is inoperative.
Enter setup mode to view diagnostic code.
"0 MINUTES" SHOWING IN DISPLAY - This condition indicates the appliance cannot be
operated. Coins dropped or debit inputs during this condition will be stored in escrow but
cannot be used until normal operation is restored by opening and closing the door. If a door
switch fails, it must be replaced before normal operation can be restored.
COLD START (Initial first use) - Appliance is programmed at the factory as follows:
Washer 14-minute wash period
3 rinses (extra rinse not enabled)
$1.75 wash price (PD models)
$0.00 wash price (PR model)
12

SETUP INSTRUCTIONS

WARM START (after power failure) - A few seconds after power is restored, if a cycle was in
progress at the time of the power failure, "RESELECT CYCLE" will flash in the display,
indicating the need for a key press to restart washer.
DOOR LOCK - The door will be locked when the cycle starts. The door will remain locked
until the end of a cycle or approximately 2 minutes after a power interruption.
PRICING - After the door is opened following the completion of a cycle, the display indicates
the cycle price (unless set for free operation). As coins are dropped or debit inputs arrive, the
display will change to lead the user through the initiation of a cycle.
FREE CYCLES - This is established by setting the cycle price to zero. When this happens
"SELECT CYCLE" will appear rather than a cycle price.
DEBIT CARD READY - This appliance is debit card "cable" ready. It will accept a variety of
debit card systems, but does not come with a debit card reader. Refer to the debit card reader
manufacturer for proper washer setup. In models converted to a Generation 1 debit card
system, debit pulses represent the equivalent of one coin.
DISPLAY - After the washer has been installed and plugged in, the display will show
"0 MINUTES." Once the washer has been plugged in and the washer door opened and closed
the display will show the price. In washers set for free cycles the display will flash "SELECT
CYCLE."