Select The Signal; Step 0 Select Cycle - Maytag NEPTUNE MAH4000 User Manual

Step 0 Select the Signal
ON Press ON or OFF for the desired signal option. ON provides an audible signal upon th_
SIGNAL completion of a cycle. OFF provides no audible signal.
OFF
O FF PREWASH
Rotate the control
dial clockwise to the
desired cycle.
Step 0 Select Cycle
CYCLES APPROX. CYCLE TIME DESCRIPTION
REGULAR The cycles located within the "Regular" area of the dial are used with most loads.
Prewash 69 minutes Use for heavily soiled loads. Use 17: times the usual amount of detergent
because the washer drains and refills with fresh water.
• • •. ••• ..••. •**• ,•, • poet• •• poop• • •pill• • • ••o, olo*e•loo•• o•o• o•••••• •• • •*** ••***i •*o el*•• • *t6*o* poe • •
Use with STAIN CYCLE option button for heavily soiled, stained loads,
Stains 59 minutes NOTE: The STAINS and HEAVY settings are not recommended for use with
Delicate or Hand-Washable loads.
Heavy 56 minutes Use for cleaning heavily soiled loads.
Normal 39 minutes Use for cleaning moderately soiled loads.
Light 33 minutes Use for cleaning lightly soiled loads.
QUICK cycle setting on the left side of the control offers the opportunity to easi-
QUICK
33 minutes ly set the washer for a quick cycle time for lightly soiled loads.
NORMAL 39 minutes NORMAL cycle setting on the left side of the control provides a NORMAL
cycle when setting the washer for a delay start.
Allows the start of the NORMAL cycle to be delayed for up to 8 hours. Set th
DELAY control dial on the desired number of delay hours, press the START/STOP but
2 - 8 hours
HOURS ton. NOTE: If the washer door is opened during the delay time, press th
STARTSTOP button again.
4