Maytag NEPTUNE MAH4000 User Manual page 12

Check these points if your Maytag Neptune
TM
washer...
Cycle Selector • Extra rinse option is selected.
Knob Advances • Washer will automatically provide an extra rinse when STAINS cycle and the
Through "OFF" STAIN CYCLE option button are selected.
• Be sure the door is tightly closed.
• Plug cord into a live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control dial to the proper cycle and push the START/STOP button.
If equipped with buttons, be sure they are fully depressed.
Won't Fill • Make sure the control dial is set on a cycle starting point. Advance the dial slightly.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Open and close the door, then push the START/STOP button.
• Check fuse or reset circuit breaker.
• Turn the control dial to proper cycle and push the START/STOP button.
Won't Tumble If equipped with buttons, be sure they are fully depressed.
• Close the door and push the START/STOP button. For your safety, the clothes washer
will not tumble or spin unless the door is closed.
• Press the START/STOP button to stop the machine.
Door Locked Shut; • It may take 1 1/2 to 2 minutes for the door lock mechanism to disengage.
Will Not Open • When "Door Locked" light goes out, pull on the door indentation opposite the hinges.
• Open the door and wash the lower portion of the gray door seal with a solution of I cup
chlorine bleach to 2 cups water.
• Select the following control panel setting: WHITES, Hot/Cold, Regular/Heavy cycle.
Freshening • Fill the bleach dispenser cup with liquid chlorine bleach and start the washer.
Your Washer • Pour an additional 1/2 cup bleach into the detergent dispenser as the washer is filling.
• Allow the washer to complete the cycle.
• At the end of the cycle, open the door and dry the gray door seal.
• Clothes washer should be leveled properly as outlined in installation instructions.
• Check the leveling leg lock nuts are tightened.
Is Noisy • Be sure rubber feet are installed on leveling legs.
• Weak floors can cause vibration and walking.
• For information on normal operating sounds, see page 12.
11