Motorola StarTAC 3000 Service Manual page 18

StarTAC 3000
Table 3: Test Commands For Manual Test Mode
Keypad Command
Entry Description
25A# SAT/DSAT ON
26# SAT/DSAT
OFF
27# CDATA
28# HITNON
29# HITNOFF
30# LOTNON
31# LOTNOFF
32# INVM
33A# DTMFON
Status
Display
Enable the transmission of SAT when A = SAT
frequency or DSAT code.
Wide call processing mode:
A SAT Freq.
0 5970 Hz
1 6000 Hz
2 6030 Hz
Narrow call processing mode:
A DSAT Code
0 2556CB
1 255B2B
2 256A9B
3 25AD4D
4 26AB2B
5 26B2AD
6 2969AB
Disable the transmission of SAT/DSAT
Transmit continuous control channel data. All words will
be the same as the "SETUP" command. When the
command starts the number of the command will be
displayed in the right side of the display.
Entering the # key will terminate the command. Trans-
mitter de-keys when finished.
Activate the high tone (1150 Hz +55 Hz)
De-activate the high tone
Activate the low tone (Frequency 770 Hz)
De-activate the low tone
Initialize non-volatile memory to factory default states.
This command should be reserved for special situa-
tions where reprogramming will be required (such as
memory chip or circuit board replacement or when a
radiotelephone is to be reissued to a new subscriber).
Does not reset ESN, NAM, phasing data or lock code.
NOTE: This command may take a minute or more to
complete; during which time the number 32
will be displayed. DO NOT turn off the radio-
telephone until the normal servicing level
display resumes.
Activate DTMF tone (A = DTMF digit, 0-9, *, #)
12
Result
6/29/98