Motorola StarTAC 3000 Service Manual page 17

Keypad Command
Entry Description
NOTE: Entering commands 20# through 23# or 27# causes the transceiver to begin a counting
sequence or continuous transmission as described below. The # key must be depressed to
exit the command; all other key depressions are ineffectual.
20# RCVS 1
21# RCVV1
22# WSTS
23# WSTV
24# (NOT USED)
6/29/98
Table 3: Test Commands For Manual Test Mode
Status
Display
Receive control channel messages counting correct-
able and uncorrectable errors. When the command
starts, the number of the command will be displayed in
the right side of the display.
Entering the # key will terminate the command and
display two three-digit numbers in the display. The first
number is the number of correctable errors and the
second is the uncorrectable errors.
Receive voice channel messages counting correctable
and uncorrectable errors (wide mode only). When the
command starts, the number of the command will be
displayed in the right side of the display.
Entering a # key terminates the command and will
display two three-digit numbers in the display. The first
is the number of correctable errors and the second is
the uncorrectable errors.
Receive control channel messages counting word sync
sequence. When the command starts, the number of
the command will be displayed in the right side of the
display.
Entering a # key will terminate the command and
display the number of word sync sequences in the
display.
Receive voice channel messages counting word sync
sequences (wide mode only). When the command
starts, the number of the command will be displayed on
the right side of the display.
Entering the # key will terminate the command and
display the number of word sync sequences.
11
Manual Test Mode
Result