Table of Contents
Advertisement
Storage and Maintenance
of Refrigerator .........
Vacations
d) remove the filter cartridge (certain models) and
install the filter bypass (see pages 16-17), dispose of
If you will be gone for a month or less, leave the con-
the used cartridge. A new cartridge can be installed
trols at the usual settings•
when the refrigerator is put back into service.
During longer absences:
e) clean and dry the refrigerator thoroughly,
a) remove all food,
f) leave the doors open to prevent odors.
b) shut off the ice maker (if installed) and the valve
where you tapped into the water line to supply the
Moving
refrigerator,
When moving, follow steps a-f under Vacations• In
c) disconnect the refrigerator from the electrical outlet,
addition, remove and carefully pack any items that are
easily removable. Ship the refrigerator in an upright
position with the doors taped shut.
eeoooeDeooeooooeoeoeoooeooooooooeooootoooeeoooo
Replacing a Light Bulb
)
.....
CAUTION."
Disconnect
the power cord before replacing
light bulbls). Wear gloves as
"" protection
against replacing
possible broken glass.
.....
Always
use a standard
40 or 60 watt appliance
bulb when replacing
a fresh food or
freezer
compartment
bulb.
Refrigerator
Freezer
There are two light bulbs located at the top of the refrig-
The freezer light is located on the back wall of the
erator compartment, on the underside of the Dual Cool '_
freezer compartment.
control housing.
*
To replace:
To replace a lightbulb(s), remove the control cover from
.........
unhook the tabs on the top of the light shield by
.......
the control housing:
pressing in with the thumb on the center top of the
:
• grasp the control cover at the two rear "finger tabs"•
light shield
These are located at the upper rear of the fresh food
• pivot the shield down
compartment, behind the light shields.
• unscrew the bulb when cool and replace it with a
• pull down slightly to clear the retainer tabs and slide
standard 40-watt appliance bulb
the cover forward until it is free.
• replace the bulb cover by pivoting it back into place
• replace the bulb(s) with a 60-watt, standard base
and snapping the tabs into the appropriate slots.
appliance bulb(s).
• After replacing the bulb(s), align the control cover on
_: . '_ _
to the ribs on the control housing and slide it straight
Dispenser Light (dispenser models only)
back until it snaps onto the retainer tabs.
To replace:
On certain models, there is an additional light located
• Locate the lightbulb in the dispenser area to the left
behind the top drawer. To replace:
of the actuator.
• remove the top drawer and cover as explained on
• Unscrew the used bulb and remove.
page 12.
carefully reach into the bulb cover and unscrew the
• Replace the bulb, using a 120V, 7-watt bulb.
lightbulb
.....
replace the bulb with a 60-watt appliance bulb.
21
Advertisement
Table of Contents
